This is the Hifi power amplifier
circuit, will be used TDA2003 ic number. The normal operation of the integrated circuit,the music amplifier for car audio radio sound.Which it uses the supply voltage from 12 volt car battery.But this circuit adapted for use at home by listening to change power supply to 15 volts.
This allows a higher watt power than the existing 3watt RMS.The TDA2003 IC is protected from damage and short circuits,When the load over.Maximum Voltage of 28 volts, the frequency response 40 Hz – 15 kHz.
When entering the power supply 15 volts to the circuit. The C1 coupling audio signal through the VR1 to adjust the volume.Then sent to the C2 anti-noise DC input signal to the pin 1 of IC.The non inverting amplifier circuit is a non-return phase.
Circuit Hi-Fi Audio Amplifier
This is the signal output pin 4, by a C5 enhances the stability of low-frequency response the better.And noise will be dropped down to ground by R4 and C6 before output to speakers.Another part of the output signal, which is fed back through C3, and R1, to enter the pin 2 inverting.
To maintain a constant frequency response at-3dB.And if you want to add. Frequency response is to reduce the C3.The C8 is a filter file before the operation.C7 cut out noise from the
supply.If you want a stereo amplifier,Is to create an additional set.